8
DXST10000
ASSEMBLY
EXPANDABLE UPRIGHT FRAME INSTRUCTIONS
• Note: For ease of assembly, two (2) Vertical Beams feature
pre-bolted horizontal and diagonal beams.
STEP 1
• Place one (1) Vertical Beam and one (1) Pre-Bolted Vertical
Beam on the floor, parallel to one another (about 24”/60.9 cm
apart). The widest part of the teardrop-shaped hole pattern
on each beam should be facing upward (or away from you).
STEP 2
• Take the free end of the diagonal beam and insert it into
the free end of the top horizontal beam. Align the holes.
Insert both beams into the U-shaped bracket at the top of
the opposing Vertical Beam, and align the holes. Using the
included hex key or hex bit, thread a vertical assembly bolt
through the holes and into the weld nut that is attached to
the U-shaped bracket. Do not fully tighten the bolt.
STEP 3
• Swing out the bottom horizontal beam, and insert it into the
U-shaped bracket at the bottom of the opposing Vertical
Beam. Thread a vertical assembly bolt through the holes and
into the weld nut that is attached to the U-shaped bracket.
Do not fully tighten the bolt.
STEP 4
• Repeat Steps 1-3 to assemble the second upright frame.
Once both are assembled, fully tighten the bolts on all
four corners. Be careful not to over-tighten the bolts; there
should be no deformation of the U-shaped brackets and/or
horizontal beams.
(61 cm)
2 ft
TOP HORIZONTAL BEAM
BOTTOM HORIZONTAL BEAM
DIAGONAL
BEAM
24
(60.9 CM)
To Next Page
Loading...
