H
H
Safety Notes
Before attempting any repairs, the following should be observed,
Ensure that the correct tool is used and only use good quality hand tools.
Ensure the workshop is clean and tidy.
Always wear protective clothing, Overalls, safety gloves, safety glasses, safety hat/net etc.
Check that guards function correctly, if not repair before running the product.
Before turning product on for analysis carry out a visual check for loose/broken parts Including
accessories, blades, cutters etc.
Carry out an Earth continuity, Earth leakage and Insulation test (flash test) where appropriate.
Never repair a product whilst it is plugged into a power supply
Remove all accessories, blades, cutters etc.
Release tension on parts before attempting to remove, for example arm springs.
After repair
Carry out Earth continuity, Earth leakage and Insulation test (flash test) where appropriate.
Ensure all guards function correctly.
Run product to check that it functions correctly, including all features.
Before attempting any necessary adjustments, ensure that the unit is not connected to the power
supply.
To Next Page
Loading...
