8
ENGLISH
cavities. Always unplug the charger from the power supply when there is no battery
pack in the cavity. Unplug charger before attempting toclean.
• DO NOT attempt to charge the battery pack with any chargers other than DeWALT.
DeWALT chargers and battery packs are specifically designed to worktogether.
• The intended uses of the DeWALT DCB094K are to charge DeWALT rechargeable
batteries, and to charge or provide power to USB powered devices. Any other uses
may result in risk of fire, electric shock orelectrocution.
• Do not expose charger to rain orsnow.
• Pull by plug rather than cord when disconnecting charger. This will reduce risk
ofdamage to electric plug andcord.
• Make sure that cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage orstress.
• Do not use an extension cord unless it is absolutely necessary. Use of improper
extension cord could result in risk of fire,electric shock, orelectrocution.
• Do not place any object on top of charger or place the charger on a soft surface
that might block the ventilation slots and result in excessive internal heat. Place
the charger in a position away from any heat source. The charger is ventilated through
slots in the top and the bottom of thehousing.
• Do not operate charger with damaged cord or plug—have them
replacedimmediately.
• Do not operate charger if it has received a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorised servicecentre.
• Do not disassemble charger; take it to an authorised service centre when
service or repair is required. Incorrect reassembly may result in a risk of electric shock,
electrocution orfire.
• In case of damaged power supply cord, the supply cord must be replaced immediately by
the manufacturer, its service agent or similar qualified person to prevent anyhazard.
• Disconnect the charger from the outlet before attempting any cleaning. This will
reduce the risk of electric shock. Removing the battery pack will not reduce thisrisk.
Charging a Battery (Fig.A)
NOTE: To ensure maximum performance and life of lithium‑ion battery packs, charge the
battery pack fully before firstuse.
1. Plug power adapter
7
into an appropriate outlet. For fastest charge rate, use the
provided DeWALT poweradapter.
NOTE: Slower charging blink pattern may occur if using lower poweradapters.