Need help?Do you have a question about the DeWalt XR FLEX VOLT DCS690 and is the answer not in the manual?
General| Power Source | Battery |
|---|---|
| Blade Diameter | 230 mm |
| Weight | 14.5 lbs |
| Battery Compatibility | FLEXVOLT |
| Cut Depth | 83 mm |
| Arbor Size | 1 inch |
| Battery Type | Lithium-Ion |
Defines safety signal words like DANGER, WARNING, CAUTION, NOTICE.
Lists specifications such as voltage, battery type, wheel diameter, and weight.
General warnings for power tool usage to prevent electric shock, fire, and injury.
Instructions on safe use of power tools related to electrical connections and environment.
Guidelines for operator alertness, protective equipment, and proper body positioning.
Instructions on proper tool usage, maintenance, and storage.
Guidelines for safe charging, use, and maintenance of battery packs.
Ensures the guard is attached and positioned for maximum operator safety.
Use only specified wheels and blades for safe operation.
Accessory speed must match or exceed tool's rated speed to prevent breakage.
Use correct, undamaged flanges to prevent wheel breakage.
Do not use wheels from larger tools; they may burst at higher speeds.
Accessory size must be within tool's capacity for proper guarding.
Ensure wheel and flange arbor holes match the tool's spindle for balance.
Inspect wheels for damage before use; test at max speed.
Wear appropriate PPE like face shields, goggles, dust masks, and gloves.
Keep bystanders away from the work area and ensure they wear PPE.
Hold tool by insulated surfaces to avoid shock from live wires.
Wait for accessory to stop completely before laying down the tool.
Do not run the tool while carrying it to prevent accidental snagging.
Avoid operating near flammable materials due to spark risk.
Do not use accessories requiring liquid coolants to prevent electrocution risk.
Warning against liquid entering the charger to prevent electric shock.
Disconnect charger from outlet before cleaning; use a damp cloth, no liquids.
Essential safety guidelines for handling and using DEWALT battery packs.
Do not charge or use batteries in explosive atmospheres due to ignition risk.
Battery liquid is flammable; keep away from sparks or flames.
Never open battery packs; damaged packs can cause electric shock or fire.
Prevent metal objects from contacting battery terminals to avoid fire hazard.
Ensure battery terminals are protected during transport to prevent fire.
Do not use the tool in environments with flammable liquids or gases.
Keep children away from the tool to prevent accidents.
Must connect water supply system when cutting concrete.
Turn off tool and disconnect battery before making adjustments or installing accessories.
Use only DEWALT battery packs and chargers for safety and compatibility.
Do not operate with an unlatched battery door; prevent water entry.
Wear gloves when changing wheels due to sharp and hot parts.
Warning: moving guard backward increases kickback risk; open wider only when required.
Always observe safety instructions and applicable regulations during operation.
Turn off tool and disconnect battery before making adjustments or installing accessories.
Always use proper hand position as shown to reduce risk of serious injury.
Hold securely to anticipate and resist sudden reactions or kickback.
LED illuminates when tool is pushed too hard; may cause hot pack or shutdown.
Grasp tool firmly with both hands before lifting to start operation.
Edge cutting requires wheels designed and specified for this purpose.
Direct open side of guard towards surface during edge cutting for protection.
Warns that wheels can break or kick back if they bend or twist during cutting.
Do not use edge cutting wheels for surface grinding due to risk of breakage.
Never use saw overhead; limit wet cutting to horizontal to prevent water entry.
Wet cut method must only be used with a diamond blade.
Never cut magnesium; its particles may ignite causing personal injury.
Cutting concrete must ONLY be done using the wet cut method.
To Next Page