Note: To activate the desired function, please rotate the knob switch to the
corresponding letter inscribed for that mode.
When using the "PIR" or "NTM" mode, toggle the "Delayed" switch (on the
back of the transmitter) to select the amount of time that the receiver can
remain on after the last detected motion, 1 minute, 5 minutes, 15 minutes
or 30 minutes are available. This switch is inoperative in the "RND" and
"D2D" modes.
Method of using time delay function
Notes: The receiver must be located within 100 feet of the remote transmitter.
Actual functional range may be affected by the following factors: weather,
radio frequency interference, low remote battery, and obstructions between
the transmitter and receiver.
Operating Instructions
1. Remove the battery cover on the rear side of the transmitter. Insert 3
"AAA" batteries according to the (+) and (-) instructions on the inside of
the battery compartment, and re-install the battery cover. Recommended
to use "NiMH batteries"
2.Plug the receiver into a powered outlet.
3.Plug your device into the socket of the receiver.
To Next Page
Loading...