Operating and Safety Instructions
Introduction
Please read these operating instructions carefully to the end. They belong to this product
and contain important information on setting up and handling this device. It is important
that you always follow the safety instructions. If you should have any questions or are
not certain how to handle this device, please visit www.dexaplan.com on the Internet
or contact your service centre. Please keep these instructions in a safe place and pass
them on to anyone who uses this device.
Intended Use
The light controller is designed to switch lights on and off automatically in order to
make others believe you are at home, for example. It should only be used in private
households. If it is to be used outdoors, a weatherproof housing should be used for
the lamps. Any use of the device other than that described below, or any modification
to the device, is not permitted and may result in hazards such as injuries and technical
malfunctions (e.g. short-circuit, fire, electric shock) or damage.
Technical Data
Fitting type: E 27
Approved illuminants: Bulb, min. 40 W to max. 100 W (in the case of closed
lampshades max. 60 W) Energy-saving lamp, min. 7 W to
max. 23 W
Safety Instructions
If damage occurs as a result of non-compliance with these operating instructions, all
guarantee claims shall become invalid! No liability will be accepted for consequential
damage! The manufacturer will not accept responsibility for damage or injury to pro-
perty or individuals resulting from improper handling or non-compliance with the safety
instructions!
Danger! Non-compliance with these instructions places the user’s life or health
in danger.
Caution! Non-compliance with these instructions places other items in danger.
Danger!
J Before installing the device, please turn the power supply off. Ensure that the
lamp socket is not live during installation and that nobody can turn the power
on again while the device is being installed.
J It is important to ensure that there is sufficient safety clearance between the illu-
minant and other items. It is possible that when the device is fitted the clearance
to combustible materials such as lampshades etc. is reduced.
J Do not open the device. The voltage inside the device is high! Otherwise there
is a possibility of electric shock and a danger of death!
J Do not insert any objects into the socket or device, as otherwise you might touch
live parts! Danger of electric shock, fire or death!
J It is essential to ensure that the device does not come into contact with water or
moisture. Otherwise there is a danger of electric shock, fire or death!
J The device should only be cleaned with a dry or slightly damp cloth, keeping
the bayonet cap and socket dry. Otherwise there is a danger of electric shock or
death.
J The device should not be left in the hands of children. It is not a toy. Otherwise
there is a danger of death!
Random Light Controller SL 614
Dexaplan
LL 33c
To Next Page
General