Need help?Do you have a question about the Dexter Power AG115-4 and is the answer not in the manual?
Keep work area clean and well lit. Avoid explosive atmospheres. Keep children and bystanders away.
Match plugs to outlets. Avoid body contact with earthed surfaces. Do not expose to rain or wet conditions. Do not abuse the cord.
Stay alert. Use personal protective equipment. Prevent unintentional starting. Do not overreach. Dress properly.
Do not force the power tool. Use the correct power for your application. Do not use if the switch is faulty.
Have power tool serviced by qualified repair person using identical replacement parts.
Read all warnings. Do not use for sanding/wire brushing. Use only manufacturer-recommended accessories. Match accessory speed and size.
Maintain a firm grip, position body to resist forces. Use auxiliary handle. Never place hand near rotating accessory.
Do not position body where tool will move if kickback occurs. Avoid corners, sharp edges, bouncing.
Do not attach saw chain woodcarving blade or toothed saw blade. These create frequent kickback.
Use only recommended wheel types and specific guards. Mount grinding surface correctly.
Guard must be securely attached and positioned for maximum safety. Helps protect from fragments and contact.
Use wheels only for recommended applications. Do not grind with side of cut-off wheel.
Always use undamaged and correct size/shape wheel flanges. Supports wheel, reduces breakage risk.
Do not use worn wheels from larger tools. Not suitable for higher speed, may burst.
Do not jam wheel or apply excessive pressure. Avoid excessive depth of cut. Overstressing can lead to binding or breakage.
Do not position body in line with/behind rotating wheel. Kickback can propel tool towards you.
Switch off tool when binding. Hold motionless until wheel stops. Never remove from cut while rotating.
Do not restart cutting in workpiece. Let wheel reach full speed before re-entering cut to avoid binding.
Support oversized workpieces to minimize pinch and kickback risk. Place supports near line of cut.
Use caution making pocket cuts in walls/blind areas. Protruding wheel may hit hidden utilities causing kickback.
Designed for grinding and cutting metal with suitable accessories. No other use is authorized.
Details nominal voltage, wattage, speed, spindle type, disc diameter, and thickness.
Explains symbols for warning, double insulation, risk of electric shock, eye protection, and dust mask.
Ensure tool is off and unplugged. Choose correct guard for grinding or cutting. Position guard for protection.
Ensure tool is off and unplugged. Press spindle lock, remove outer flange and disc. Do not remove inner flange.
Assemble in three positions. Screw into attachment points and ensure it is securely fastened.
Use hold-to-run switch with safety interlock. Press safety interlock, then hold-to-run switch fully.
Use grinding guard. Position tool at 30-40 degree angle. Move tool back and forth with light pressure.
Use cutting guard. Move tool forward without forcing. Do not tilt or move side to side. Work upwards.
Have carbon brushes replaced by a qualified repair person. Replace both brushes at the same time.
Store accessories in dry place. Clean tool with cloths. Ball bearings are pre-lubricated.
Requires proof of purchase, no third-party repairs, no improper use, no external damage, and adherence to safety instructions.
General| Power | 1150 W |
|---|---|
| Disc diameter | 115 mm |
| Spindle diameter | M14 |
| No load speed | 11000 rpm |
| Spindle thread | M14 |
| Power source | Corded Electric |
To Next Page
