5.5
Visual Inspection of the Connection
After connecting the battery, check for:
Usage of positive and negative cables.
Connection of the positive and negative terminals.
All the bolts are tightened.
Cables fixation and the appearance.
The installation of the protecting cover.
5.6
Activate the Product
A.
Hang the RW-M6.1 battery on the wall as shown on 5.4.
B.
Connect the wires according to the picture on 5.4.
C.
Turn on all battery power in turn.
Start the Battery:
After installation, wiring, and configuration are completed, you must check all the connec-
tion. When the connections are correctly, and then press power button to activate the bat-
tery. The green working light on the front panel of the battery flashes, indicating that the
battery system is normal.
6
Inspection, Cleaning and Maintenance
6.1
General Information
The battery product is not fully charged. It is recommended that the installation be com-
pleted within 3 months after arrival;
During the maintenance process, do not re-install the battery in the battery product. Oth-
erwise, the performance of the battery will be reduced;
It is forbidden to dismantle any battery in the battery product, and it is forbidden to dis-
sect the battery;
After the battery product is over-discharged, it is recommended to charge the battery
within 48 hours. The battery product can also be charged in parallel. After the battery
product is connected in parallel, the charger only needs to connect the output port of any
product battery.
Never attempt to open or dismantle the battery! The inside of the battery does not con-
tain serviceable parts.
Disconnect the Li-Ion battery from all loads and charging devices before performing
cleaning and maintenance activities
Place the enclosed protective caps over the terminals before cleaning and maintenance
activities to avoid the risk of contacting the terminals.
6.2
Inspection
Inspect for loose and/or damaged wiring and contacts, cracks, deformations, leakage, or
damage of any other kind. If damage to the battery is found, it must be replaced. Do not
To Next Page
Loading...