M
Michael KellerJul 27, 2025
What does it mean when my Deye SUN600G3-EU-230 has a grid failure?
- DDana ReidJul 27, 2025
A red LED blinking three times indicates a grid failure.
To Next PageTo Next PageWhat does it mean when my Deye SUN600G3-EU-230 has a grid failure?
A red LED blinking three times indicates a grid failure.
General| Model | SUN600G3-EU-230 |
|---|---|
| Category | Inverter |
| Start Voltage | 22 V |
| Number of MPPT Trackers | 2 |
| Number of Inputs per MPPT | 1 |
| Nominal AC Output Power | 600 W |
| Nominal AC Voltage | 230 V |
| AC Voltage Range | 180-280V |
| Rated AC Frequency | 50/60Hz |
| AC Frequency Range | 45-55Hz/55-65Hz |
| Power Factor | >0.99 |
| Total Harmonic Distortion (THD) | <3% |
| Operating Temperature Range | -25°C to +60°C |
| Cooling Method | Natural Convection |
| Enclosure Rating | IP65 |
| MPPT Voltage Range | 25-55V |
Highlights RCD usage, qualified personnel, reading documentation, electric shock risk, and surge protectors.
Details installing the junction box, wiring AC cables, and connecting to the network.
Guides on marking locations and mounting microinverters onto the PV module frame.
Instructions for fitting AC cable protection and connecting to PV modules with LED indicators.
Outlines the steps to switch on AC circuit breakers and start power generation.
Introduction to troubleshooting steps for a non-functioning PV system.
Provides a quick method to diagnose microinverter or communication problems.
Lists sequential steps for dealing with a malfunctioning microinverter, checking voltage, connections, and switches.
Step-by-step guide on how to safely disconnect and replace a failed microinverter.
Steps to open a wireless network, select logger network, and establish a connection.
Guides on opening a browser and entering the IP address to access the setup page.
Instructions to update and connect to the desired wireless network via the setup guide.
Confirms successful configuration and prompts for system restart.
Confirms successful device configuration and where to check device status.
