DFI CA64-TN - Page 71

71
!
Award BIOS Setup Utility
Assign IRQ for VGA
When Enabled, the system automatically assigns an IRQ for the VGA
card installed. Your VGA card will need an IRQ only when using the
video capture function of the card. If you are not using this function,
set this field to Disabled. The IRQ previously occupied by the VGA card
will be available for another device.
Note:
When Disabled, a Yellow mark will appear in Windows

95s
Device Manager.
Assign IRQ for USB
When Enabled, the system automatically assigns an IRQ for the USB
device connected to your system. However, if you are not using USB
devices, set this function to Disabled. The IRQ previously occupied by
the USB device will be available for another device.
Note:
When Disabled, a Yellow mark will appear in Windows

95s
Device Manager.
PCI Slot 1,5 Use IRQ to PCI Slot 4 Use IRQ
By default, an IRQ is automatically assigned to each PCI slot. You
may also manually assign an IRQ to these slots. The options are: 3, 4,
5, 7, 9, 10, 11, 12, 14 and 15.