Why does the salt level indicator stay on after adding salt to my DH Lifelabs Aaira Mini Air Cleaner?
If the salt level indicator is still displayed on your DH Lifelabs Air Cleaner even after adding salt, it might take some time for the salt to dissolve and for the system to monitor the actual concentration. If the issue persists after a while, discard the salt water solution and prepare a new batch, carefully following the instructions.
What to do if the salt level indicator is flashing after adding salt to my DH Lifelabs Aaira Mini Air Cleaner?
If the salt level indicator is flashing on your DH Lifelabs Air Cleaner after you've added salt, ensure that you've added the correct amount of salt. If the problem continues, discard the salt water solution and mix a new batch, carefully following the provided instructions.
Why does the air from my DH Lifelabs Aaira Mini sterilizer smell bad?
If the air from your DH Lifelabs Air Cleaner sterilizer smells bad, check that the water tank and CEF are clean. Regularly clean the water tank and replace the CEF as needed.
What to do if water level indicator is still flashing on my DH Lifelabs Aaira Mini after adding water?
If water was added to the water tank of your DH Lifelabs Air Cleaner and the water level indicator is still flashing, discard all the water in the tank and check again. If the issue persists, contact Customer Assistance.
How to reduce chlorine smell from my DH Lifelabs Aaira Mini Air Cleaner?
If your DH Lifelabs Air Cleaner emits a chlorine or disinfection smell, you can switch to sleep mode to reduce the smell in the room.
What to do if my DH Lifelabs Air Cleaner sterilizer has been tipped over?
If your DH Lifelabs Air Cleaner sterilizer has been tipped over or fallen, immediately unplug the power cord. Lift up the sterilizer and wipe off any water on the surface. Allow the sterilizer to dry completely before using it again.
General| Brand | DH Lifelabs |
|---|---|
| Model | Aaira Mini |
| Category | Air Cleaner |
| Language | English |
Adheres to critical safety instructions to reduce risks of fire, electric shock, or injury during device operation and maintenance.
Captures large airborne particles using a screen-based pre-filter.
Disperses HOCI molecules from evaporated water to destroy bacteria and viruses in the air.
Explains the operation of On/Off, Fan Speed, Timer, Disinfect, and CEF Replacement Indicator buttons.
Details the Low Salt, High Salt, and Low Water alerts, including their visual and audible signals.
Addresses low air flow, unusual smells, device tipping, and salt/water level indicator problems.
To Next Page
