To Next Page

To Previous Page

Note that nothing will be seen on the display until the tester is connected

to a vehicle battery.

3. Make sure the battery terminals are clean. Wire brush them if necessary.

Clamp the black load lead to the vehicle negative battery terminal. Clamp the

red load lead to the vehicle positive battery terminal. Please clamp on the lead

part of the terminal only. Clamping on the iron part of the terminal will lead to

wrong test results.

Questions and Answers:

Need help?

Do you have a question about the DHC BT900 and is the answer not in the manual?

DHC BT900 Specifications

General