DHC BT900 User Manual

9
11.
Press the ◄ ► key to select battery fully
charged or not if tester asks. Press «ENTER» to
confirm choice.
IS BATTERY
CHARGED?
YES/NO
12. When the test is completed, the display shows the actual volts and the actual
CCA and internal resistance. {Press the ◄ ► key to read: SOH (STATE OF
HEALTH) and SOC (STATE OF CHARGE)}.
13. One of the six test results will be displayed:
GOOD & PASS
*The battery is good and capable of holding a
charge.
GOOD & PASS
VOL:
xx.xx V
CC
A:
xxxx CCA/SAE
IR:
xx.xx mΩ
GOOD & RECHARGE
*The battery is good but needs to be recharged.
GOOD &
RECHARGE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
CAUTION
*The battery may be serviced but decrease the
capability of starting the engine gradually. The
battery may fail under extreme climate
conditions. There may be a poor connection
between the vehicle and the battery affect the
charging function. Please pay attention to the
battery for replacement consideration and
charging system checking.
CAUTION
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
RECHARGE & RETEST
*Battery is discharged, the battery condition
cannot be determined until it is fully charged.
Recharge & retest the battery.
RECHARGE &
RETEST
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
BAD & REPLACE
*The battery will not
hold a charge. It should be
replaced immediately.
BAD & REPLACE
VOL:
xx.xx V
CCA:
xxxx CCA/SAE
IR:
xx.xx mΩ
9

DHC BT900 Specifications

General

Brand	DHC
Model	BT900
Category	Measuring Instruments
Language	English