EasyManua.ls Logo

DHK Hobby D302 - Page 2

DHK Hobby D302
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Thank you for purchasing DHK 2.4GHz radio system. Please read the following
instructions before you operate your transmitter. This instruction provides a general
guideline for this transmitter. When you drive your vehicle together with this 2.4GHz
transmitter, please pay special attention to safety precautions. Besides, good common
sense in RC driving is always important. Enjoy your play!
Safety precautions
1. The 2.4GHz transmitter and receiver are pre-bound at the factory.
2. Please always use the same receiver model from the factory to match your 2.4GHz
transmitter when you need to replace it. Receivers from other suppliers mostly don't work
on DHK 2.4GHz transmitter.
3. When you need to replace a receiver, please make sure that it is bound with the
transmitter before use.
4. Please operate the transmitter in vast areas where no radio interference exists. It's
strongly recommended that no humans, animals or high voltage grid should be nearby.
5. Please do not operate this transmitter during fatigue, sickness, intoxication or in bad
mood.
6. Do not operate the transmitter at night time, in the rain and thunderstorm or at low
visibility.
7. Always use the same types of batteries in the transmitter. Do not mix old and new
batteries in the transmitter. Please check the battery power before use. Replace batteries
whenever the power is low to avoid out of control. Ni-Mh or Ni-Cd rechargable batteries
can be used on this transmitter. Please charge the batteries to full before use.
8. Before you operate the transmitter, please check the switch, batteries, servo and ESC
for proper connection.
9. ALWAYS switch on the transmitter first, and off last so as to avoid possible radio
interferrence from other sources. Failure to do so may cause out of control of your vehicle.
10. Before operation, check the servo forward and reverse functions, motor range, and
neutral postion. Modify it when necessary.
11. Please handle the transmitter with care. Store the transmitter in a dry and clean place
when it's not in use for some time.
1