Need help?Do you have a question about the Diablo Controls, Inc. DSP-55 and is the answer not in the manual?
Details on sensitivity levels, frequency settings, and response times for the DSP-55 detector.
Covers operating voltages, solid-state output ratings, and current draw characteristics.
Specifies the operating and storage temperature ranges and humidity limits.
Provides physical size, mounting position, and housing material details.
Describes the advantages and limitations of the detector's solid-state outputs.
Details the process and behavior of the detector during a reset event.
Explains how the detector senses and holds vehicle presence over the loop.
Covers pulse on entry and pulse on exit operations for loop and magnetometer modes.
Guides users on setting the detection sensitivity levels using the rotary switch.
Explains how DIP switches 9 and 10 control operating frequencies to prevent interference.
Details how DIP switch 8 selects between inductive loop and magnetometer modes.
Explains DIP switch 7 for selecting presence detection hold time.
Describes how DIP switches 5 and 6 configure Output B modes like True Presence and Pulse.
Explains DIP switch 4 for increasing sensitivity after initial detection.
Details DIP switch 3 settings for Output A's failure mode behavior.
Explains how DIP switches 1 and 2 control output delay and extension times.
Describes the meaning of Power, Detect A, and Detect B LED states.
Guidance on selecting a location, mounting, and wiring the detector unit.
Covers wire type, gauge, and general installation practices for vehicle detection loops.
Details on loop dimensions, turns, slot cutting, and sealant for optimal performance.
Focuses on saw slotting techniques, corner cuts, and cleaning for loop integrity.
Instructions for installing the free exit probe accessory with the detector.
Defines the function of each pin on the DSP-55 detector's wiring connector.
Steps to diagnose and resolve issues when the detector's power LED is off.
Diagnosing open loops, high resistance, or excessive inductance indicated by slow flashing.
Diagnosing shorted loops, low resistance, or insufficient inductance indicated by fast flashing.
Resolving intermittent failures where the detector is functioning but has encountered a fault.
Addressing issues where the detect LED behaves incorrectly without a vehicle present.
Steps to fix the detect LED not activating when a vehicle is present.
General| Brand | Diablo Controls, Inc. |
|---|---|
| Model | DSP-55 |
| Category | Security Sensors |
| Language | English |
To Next Page