13
The following steps 8 & 9 are for Model CT400 and CT800 saws only
8. Use the up and down arrow keys to specify the rock angle. Select 0 if you do not wish to have
any rock action.
9. Use the up and down arrow keys to specify rock speed. You have three choices: slow, medium
and fast.
10. Use the up and down arrow keys to select between Bow Calculated or User Specified for the
Yoke Velocity Method:
Bow calculated You specify a target bow angle and the controller automatically adjusts
yoke velocity to maintain the desired wire bow. Proceed with Step 11.
User specified You specify fixed velocity values to control the downward motion of the
yoke. Skip to Step 12.
To Next Page
Loading...