Diamond HEX - Page 4

RAF
Each HEX component crossover has a third set of outputs marked "RAF ". This stands for Rear
Acoustic Fill. This output can be used to power an additional speaker off the same channel
without affecting the impedance load on the source unit. The level of this output is determined by
the jumpers in the crossover marked "REAR". The jumper has setting for -lOdB of attenuation,
-SdB of attenuation or off . When off, the RAF outputs are flat, or have no attenuation.
Rear-Fill Driver
Tweeter
THIELE/SMALL PARAMETERS
Parameter (unit)
Sensitiv i ty- 2.83V@lm ( dB )
Qts
Fs (Hz)
Vas (L)
Re (ohm)
Xma x ( mm)
Impedance (ohm)
RMS Power (watts )
Peak Power (watts)
PHYSICAL DIMENSIONS
Model (inches)
Total Diameter (A)
Mounting Diameter (B)
Screw Ho le Diameter ( C)
Moun t ing Depth (D)
Magnet Diameter (E)
H500
86
0.70
70
6.3
3.5
2.3
4
75
I SO
H500
5 .5
5
5.2
2 .1
3.5
H600
S.Ota S.Ots
87
92 91
0.6 0
0.54
0.65
58
1 650 1520
12 .7
n/ a
n/a
3.7
7 6.5
4.0
n/ a n/a
4
8 8
85
50 45
170
10 0 90
H600
S.Ota/s
6.3 2.3
5 .4 2
5.9
n/a
2.4
0.8
3.8 n/a
~ I ~ ( A) .I
Amplifier Ill
ll l lf iLIII/ 111 t rr r ~ '\ I ~ ~NIIG?:tz ~~
...
I_
I
Mid-range Driver
(E)
(B)
~