SWITCHES
2 / 6 STG
This toggle alternates between 2 or 6 stages of phasing. 2 stages provides a subtle sweep
while 6 stages is a much deeper ‘swirl’ reminiscent of 70’s prog rock.
PHS / VIB
When switched to VIB the dry signal is removed from the output mix. The resultant
sound has more ‘throb’ and less sweep. VIB mode is also useful in conjunction with amps
that feature a parallel effects loop- because dry signal is being mixed with the effect at the
amplifier, VIB mode helps to preserve the phase effect.
ON / OFF
This switches the entire effect circuit between bypass and in-circuit operation, with a
green LED indicating that the effect is bypassed and a red LED indicating the effect is
engaged.
INPUT / OUTPUT JACKS
INPUT
The input jack is located on the right side of the pedal and is indicated by the “<“ symbol.
Plug in your guitar, the output of another pedal or the ‘send’ of your effects loop into this
jack.
EXP
The EXP or expression jack is located on the right side of the pedal below the INPUT
jack. Plug in an expression pedal to manually control SPEED ‘on the fly’.
DIR
The DIR output is located on the left side of the pedal and provides a buffered dry signal
to send to a second amp in a stereo setup or effects chain.
OUTPUT (mono)
This output is located on the lower left side and is indicated by the “<“ symbol. It pro-
vides a dry signal when the pedal is bypassed and an effected signal when the pedal is
engaged. Plug the output of this jack into your amp, the input of another effect or into the
‘return’ of your effects loop.
POWERING
ADAPTER
The Phase comes standard with a 24V switching power supply. This power supply will
work anywhere in the world (some locales may require a simple physical adapter).
!
Phase user manual v1.00! 4
To Next Page
Loading...
Need help?
General
