11
The Rear Panel cont.
OUTPUT: This is a stereo 3.5mm jack that outputs the
same signal that is being played. The audio signal that
comes out here is volume knob dependent, but Bass
and Treble tone control independent so they have no
effect on the audio on this jack. While this might have
been useful when a subwoofer is connected, it is a bad
thing when the jack is used to daisy-chain several
DiamondBoxxes together.
The Bluetooth
To connect your Bluetooth device:
1. Turn on the DiamondBoxx
2. Start the Bluetooth service on your mobile device
3. Click on "DiamondBoxx M3"
The Bluetooth range should be near 100 feet if
unobstructed. Putting things between like human
bodies and walls will decrease this. Lifting the
DiamondBoxx off the floor or ground will usually
increase the range.
If having trouble connecting, first check that another
device isn’t already connected, this is usually the reason
for connection troubles. If not solved power the
DiamondBoxx off for 60 seconds. Open the Bluetooth
devices list on the device you wish to connect.
To Next Page
Loading...
