5
The MODE/TWS Switch - TWS function
To wirelessly connect two 2
nd
generation DiamondBoxx
perform the following:
1. Power on the DiamondBoxx that will be the
MAIN unit
2. Connect the Bluetooth device to it
3. Power on the DiamondBoxx that will be
SECONDARY unit
4. Press and hold the TWS button on Main
DiamondBoxx until the LED under the letter
“M” blinks rapidly, then release button.
5. Press and hold the TWS button on the
Secondary DiamondBoxx until the LED
under the letter “S” blinks rapidly, then
release button.
6. Wait for up to 2 minutes for the
DiamondBoxxes to form a secure
connection. (It may pause the music on the
Bluetooth device transmitting music so you
may have to restart your music)
7. If after 2 minutes you are unable to make a
connection press and hold the TWS button
on both DiamondBoxxes (one at a time)
until the LED under the letter “C” flashes
rapidly and then release button. This
should clear the TWS system, now start
from step 1 again.
8. Note the 2 DiamondBoxxes must be less
than 30 feet from each other typically.
To Next Page
Loading...
