dicodes Dani Box Micro - 07 Device Charging; USB-C and CS1 Charging Options

07Charging
Chargingthedevice
Thedevicehastwochargingoptions:
TherecommendedchargingmodeistousethebuiltinUSB-Cconnectiontoareadilyavailable(wall-)
power-supplywithUSB-Aoutput,withaminimumoutputcurrentof2Amps.NotethattheUSB-Cport
ontheDaniBoxMicroisachargeonlyport.
UseanadapterofUSB-CtoUSB-AifyoursourcehasanUSB-Coutputonly.
ThesecondoptionistousethechargingcontactwiththeuseoftheCS1chargestationbydicodes.
ThechargecurrentoftheCS1dependsonthecontactresistancebetweendeviceandstationistypically
1A(2Amaximum,limitedbytheCS1).
AlwaysusethededicatedinlayfortheDaniBoxMicro,whenusingtheCS1.
Importantnote:TheDaniBoxMicroisverylightweightdueitssmalldimensions.Theweightmight
betoolowforasufficentlygoodcontacttothespringpinsoftheCS1.Werecommendtochargethe
DaniBoxMicrowithanatomizerattachedtothe510connectortoincreaseweight.