2.
001
U s i n g t h e O v e r r i d e K e y
Remove the cover of decoration (See Figure A), you will see the override keyhole.
Insert the override key (See Figure B) into its hole and turn it clockwise .
Then turn the knob clockwise to open the door of Private Container.
(Please remove the override key in time after operation.)
Cover of Decoration
Knob
Override keyhole
Note: Please keep your override keys in
a safe place. Do not place them in
this Private Container!
To R e p l a c e t h e B a t t e r i e s
When red LED flashes during you are operating the Private Container, it indicates
that the batteries are low and need to be replaced with new ones in time.
Replacing Method:
Open the door of Private Container, remove the battery compartment cover on the
back of the door, then remove the old batteries and install the new ones properly as
the polarity marks show. Replace the compartment cover into its place.
Recommend to use LR6 AA batteries, and attend its polarity marks!
To B o l t D o w n t h e P r i v a t e C o n t a i n e r
Place the Private Container where it will be installed. Mark the locations of the
bolt-down holes back (or underside) of the Private Container, drill the holes, then
install and tighten the bolts and nuts.
Shanghai Diebold Security Equipment Co., Ltd.
Add. : 1188 Caobao Rd., Shanghai, 201102, P.R. China
Tel : 86-21-6480 1118 Fax : 86-21-6480 1238
Website: http:// www.diebold.cn
Figure A
Figure B
1 2 3
4
5
6
7 8 9
0
＃
＊
1 2 3
4
5
6
7 8 9
0
＃
＊
To Previous Page
Loading...