7.4.2 Single Channel Mode – Automatic Channel Recognition
Your Herbert can automatically recognize the pedal’s send/receive channel. To
get your amp into the mood (or mode) for this, push and hold “Mute” and then
activate any program change button on your MIDI pedal. The amp will look for a
program change and recognize the channel it is being sent on. Then it will switch
to this channel and stay there as soon as you let go of “Mute”.
7.4.3 Single Channel Mode – Manual Channel Selection
If you would like to have your Herbert on a certain MIDI channel, then we can
accommodate you here as well. Here is how this works:
Push and hold “Mute” and then turn on the preamp channels in the order that
corresponds to your midi channel preference. For example: if you want to have
your Herbert to respond only to MIDI information that is being sent on channel 7,
then you must hold the “Mute” button down and turn the Preamp channel one
selector off, channel two selector on, channel 3 selector on. If you let go of
“Mute” now, then your Herbert is set to respond to MIDI channel 7 only. Get it?
The table below gives you the sequence for all 7 MIDI channels.
Ch.1 off off off
Ch.2 on off off
Ch.3 off on off
Ch.4 on on off
Ch.5 off off on
Ch.6 on off on
Ch.7 off on on
7.5 Program Information
Herbert can remember up to 128 program changes.
7.6 Phantom Power
Several of the pins in the MIDI jack can supply phantom power to your MIDI
pedal, as explained in chapter 3.3.1
Chapter Eight: Remote 7
The optional Remote 7 footswitch can be connected via the rear panel mounted
XLR jack. The Remote 7 will not recognize functions selected from the front
panel. To reset, just unplug and plug in the Remote 7.
Remote 7 will be available soon. Please check with your local Diezel Dealer.
To Next Page
Loading...
