Digatron DT-30K - Instrument Functions; Power and Recording Operations; Viewing Overall Maximums; Reviewing Lap Times and Maximums

Instrument Functions
Start Vehicle. Instrument turns on automatically. If you are using the
optional infrared beacon transmitter and receiver, the instrument starts
recording lap times automatically when a transmitter signal is received.
A. Power/Record
B. Overall Maximums
Press &
hold to view
maximums
and best lap
time.
1. 2.
Press & release
to cycle through
up to three sets
of data.
3.
Repeat steps
1 & 2 as
desired.
MODE
MAX
MODE
MAX
4.
EXIT
REVIEW
Return to monitor / record mode.
C. Lap Times & Maximums per Lap (optional)
1.
EXIT
REVIEW
Shows lap time for the first lap of the last Event. (Button
press is ignored if instrument is receiving a tach signal.)
2.
OR
Changes lap backward or forward one.
Displays flash when best lap is shown.
Displays E#, when changing to a different
Event. Hold to jump between Events.
LIGHT SET UP
3.
Changes the functions being displayed.
Maximums for the current lap are displayed.
MODE
MAX
D. Reset (clear memory)
1.
AND Press and release at same time.
2.
Press when display flashes. Canceled if not pressed
within 10 seconds.
SET UP
EXIT
REVIEW
SET UP
E. Power Off
The instrument will turn off automatically if it does not receive
any button presses or a tach signal.
1.
Turns instrument off, if it’s not recording
or receiving a tach signal.
OR
MODE
MAX
LIGHT
AND
3