Digi-Code 5040 User Manual

Installation Instructions
Garage Door Opener Radio Controls
Model 5040 (300 mHz) \ 5042 (310 mHz) Single Button Mini Transmitters
Model 5050 (300 mHz) \ 5052 (310 mHz) Dual Button Mini Transmitters
WARNING:
•• Disconnect operator power before any installation or repair
•• Always wear safety glasses
Your Digi-Code radio controls are designed specifically to remotely control a garage
door opener and to give years of trouble free service without adjustment. Because all
radio controls are set with the even numbered switches in the “ON” position when
they leave the factory, it is recommended that a different code be selected and set at
the time of installation. Please refer to the “Setting the Code Switch” section for
instructions. The radio frequency (RF) portion of the controls, however, are tuned to
standard frequencies and are thoroughly tested at the factory. This permits the addition or
replacement of either the transmitter or the receiver by specifying the Model number and
the RF frequency designated on the identification label. RF adjustments are not needed
nor should any be attempted.
SECTION #1
ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT
The models 5040, 5042, 5050 & 5052 mini transmitter cases are made up of two halves
which are held together by a small phillips head screw. Removing this screw will allow
access to the code switches and the battery compartment ( see diagram #1 ).
( Diagram #1 )

Digi-Code 5040 Specifications

General

Frequency	300 MHz
Number of Buttons	4
Coding Type	Dip Switch
Type	Garage Door Remote Control
Power	12V
Battery Type	23A

Summary

SECTION #1: ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT

ACCESSING THE CODE SWITCH AND BATTERY COMPARTMENT

Describes how to open the transmitter case to access code switches and battery by removing a small screw.

SECTION #2: SETTING CODE SWITCHES ON 5040/5042 TRANSMITTERS

SETTING THE CODE SWITCHES ON THE MODEL'S 5040 AND MODEL 5042 SINGLE BUTTON MINI TRANSMITTERS

Details setting the 10 code switches on 5040/5042 single-button transmitters to a desired code.

SECTION #3: SETTING CODE SWITCHES FOR 5050/5052 TRANSMITTERS

SETTING THE (“RECEIVER” ) CODE SWITCHES - TO WORK WITH MODEL 5050 AND MODEL 5052 DUAL BUTTON MINI TRANSMITTERS

Explains setting receiver code switches to match transmitter codes for 5050/5052 dual-button units.

SETTING THE TRANSMITTER CODE SWITCH – MODEL'S 5050 & 5052

Details setting the 9-position code switches on the 5050/5052 transmitter, with the 10th switch set to ON.

SETTING RECEIVER #1 (WORKS WITH LEFT BUTTON ON TRANSMITTER)

Instructions to set receiver #1 code switches to match transmitter codes for operation with the left button.

SETTING RECEIVER #2 (WORKS WITH RIGHT BUTTON ON TRANSMITTER)

Instructions to set receiver #2 code switches to match transmitter codes for operation with the right button.

SECTION #4: TRANSMITTER BATTERY REPLACEMENT

TRANSMITTER BATTERY REPLACEMENT

Explains accessing the transmitter battery compartment by removing a screw and specifies a 12-volt battery.

TO REPLACE OR ADD A SET

Information on purchasing replacement units and matching digital codes to companion receivers.

OPERATIONAL CHECK

OPERATIONAL CHECK

Steps to verify transmitter and receiver functionality by testing operation from a distance.

WARRANTY INFORMATION

WARRANTY

Details the 18-month warranty, its limitations, and Digi-Code's non-responsibility for installation or consequential damages.