Digi Connect Family Application Guide – Digi to Juniper Configuration
3/16/2009 Digi International 8 of 9
11. Choose the Security Level of Custom.
12. Under Remote Gateway, choose the option of Predefined, and select the gateway that
was just setup. Click Advanced and fill in the following:
a. Phase 2 Proposal – g2-esp-3des-sha
b. Enable Replay Protection
c. Enable Proxy-ID
i. Local IP/Netmask – Local Subnet
ii. Remote IP/Netmask – Remote Subnet
13. Click Return.
14. Click Ok.
15. Navigate to Policies.
16. At the top of the page, under the From drop down box, select Trust. Under the To
drop down box, select Untrust. Add the following:
a. Source Address – Choose Address Book Entry and choose the local
subnet that was previously setup from the drop down list.
b. Destination Address – Choose Address Book Entry and choose the
remote subnet that was previously setup from the drop down list.
c. Action – Tunnel
d. Tunnel – Choose your VPN from the list
e. Check the box for “Modify matching bidirectional VPN policy” to
automatically setup the permissions for the opposite direction.
17. Click Ok.
To Next Page
Loading...
