Digi TransPort WR41 - Page 20

TransPort
®
WR41 Utility Installation Guide
Page 20
To stop the DHCP server from serving addresses, use the following command:
Command Description
DHCP 0 IPMIN X Removes the minimum IP address that will be server via
DHCP, disabling the DHCP server
As an example, to stop the DHCP sever from DHCP requests, enter the command DHCP 0 IPMIN !. The !
variable is used to remove a value or set it back to its default.
To retain the DHCP server, but on a different subnet, the following parameters will need to be congured:
Command Description
DHCP 0 IPMIN x.x.x.x Minimum IP address to assign, the start of the DHCP pool
DHCP 0 IPRANGE The number of IP addresses in the DHCP pool
DHCP 0 GATEWAY x.x.x.x The IP gateway address the DHCP clients should use
(normally this router’s LAN IP address)
DHCP 0 MASK x.x.x.x The subnet mask DHCP clients should use
DHCP 0 DNS The DNS server DHCP clients should use
For more information on CLI commands, visit http://www.digi.com/support/ and view the various reference
manuals available.