To Next PageTo Next Page
Need help?Do you have a question about the DigiDesign Pro Tools HD Accel and is the answer not in the manual?
General| Type | Digital Audio Workstation |
|---|---|
| Manufacturer | DigiDesign (Avid) |
| Compatibility | Pro Tools HD systems |
| Audio Channels | Up to 192 audio channels |
| DSP Chips | Multiple DSP chips |
| Latency | Low latency performance |
| Expansion | PCI or PCIe (depending on the specific card version) |
| Supported Sample Rates | Up to 192 kHz (system-dependent) |
| Use Case | Professional audio recording, mixing, and processing |
Overview of Pro Tools HD systems without an expansion chassis.
Explains how to use expansion chassis to increase PCI card slots.
Instructions for safely powering on expansion chassis and computer.
Details on system requirements and supported hardware configurations.
Guide on grouping and installing Pro Tools cards in correct slot order.
Explains sample rate limitations and automatic card deactivation.
Step-by-step instructions for installing Pro Tools cards into computers.
Detailed guide on using TDM FlexCables to connect Pro Tools|HD cards.
Instructions for connecting various Digidesign audio interfaces to HD systems.
Explains DigiLink cable functionality and system connectivity.
How to connect older Digidesign MIX-series audio interfaces.
Method to confirm identity of connected audio interfaces in setup.
Details on the Magma 7-Slot expansion chassis, including slot layout.
Steps to connect and configure the Magma 7-Slot expansion chassis.
Instructions for installing Pro Tools HD cards into the Magma 7-Slot chassis.
Information on the Digidesign 13-Slot expansion chassis and its layout.
Steps to connect and configure the Digidesign 13-Slot expansion chassis.
Details on the Digidesign 7-Slot expansion chassis, including slot layout.
Steps to connect and configure the Digidesign 7-Slot expansion chassis.
Instructions for installing Pro Tools HD cards into the SBS 7-Slot chassis.
