PASS THRU POWER
Pass thru power allows you to record indenitely and
keep your battery charged up at the same time.
1. Open the micro USB port door as noted on page 4 .
2. Connect the micro USB cable to a power source such
as a USB car charger, wall charger, or power bank
3. You do not need to press the power button on the
ActionPack, it starts working automatically.
4. Operate the camera as you normally would
REMOVING YOUR CAMERA FROM THE
ACTIONPACK CASE AFTER IT HAS BEEN
IN WATER
1. Visually inspect the camera, dry o any residual
water found before opening the case.
2. Hold the camera so the side with the power button
is facing down.
3. Unlatch the casing and pivot the frame away from
the camera
4. Remove the camera with the USB port side still
facing downward.
5. Visually look for any water around the USB C port on
the camera, if any is found dry it immediately.
To Next Page
Loading...