Digiprog Ltd. www.digiprog.com
© 2007 by DigiProg Ltd INTRODUCTION Page 10
Finally some important points to remember.
Always connect the Eeprom to the ST01 or ST04 before you
connect to the DigiProg this will avoid Electro static feedback
(ESD).
Never solder the connections whilst the lead is connected to the
programmer, this will damage the DigiProg.
Please do not sit at home or in your car & play with the DigiProg to
see which cars it can do. If you press the DigiProg function keys the
DigiProg will start looking for the Cars protocol, you wouldn’t ask
your PC to print if there was no printer.
Always keep your DigiProg in its case when not in Use & keep it in a
dry environment at night (don’t leave it in the trunk of your car)
If you are using solvents to remove lacquers’ from Eeprom’s ensure
that they are cleaned completely as the solvent can damage the
clips.
We hope you will have many years of use from your DigiProg, don’t
forget if you are not sure ask the helpdesk.
To Previous Page
Loading...