DIGITAL-LOGIC AG SM800/900DK Technical Manual V1.2B
2
For internal use only:
File: SM800-900DK_V1.2B.doc
Path: R:\HANDBUCH\smart\SM800-900DK\SM800-900DK_V1.2B.doc
COPYRIGHT
2008 BY DIGITAL-LOGIC AG
This publication is protected by copyright and all rights are reserved. No part of this document may be
reproduced, transmitted, transcribed or stored in a retrieval system, in any form or by any means, electronic,
mechanical, optical, manual, or otherwise, without the prior written permission of DIGITAL-LOGIC AG.
The software described herein, together with this document, are furnished under a license agreement and
may be used or copied only in accordance with the terms of that agreement.
About this Manual and How to Use It
This manual is written for the original equipment manufacturer (OEM) who plans to build computer systems
based on the single board MICROSPACE-PC. It is for integrators and programmers of systems based on the
MICROSPACE-Computer family. This manual provides instructions for installing and configuring the board,
and describes the system and setup requirements. This document contains information on hardware
requirements, interconnections, and details of how to program the system. Please check the Product CD for
further information and manuals.
REVISION HISTORY:
Document
Version
Date/Initials: Modification:
Remarks, News, Attention:
V1.0 04.2008 KUF New release of the DK manual
V1.0A 05.2008 DAR Chapter 12.2
V1.1 05.2008 KUF Added Signal Definitions / Corrections to Integration Checklist /
Interfaces supplemented
V1.2 05.2008 KUF SUSC specified, program example for GPIO30/31/34 in 13.7.
V1.2A 05.2008 KUF Detail corrections. Checked all voltagelevels on X200.
V1.2B 05.2008 KUF Data sheets from Intel and PULSE added
Attention!
1. All information in this manual, and the product, are subject to change without prior notice.
2. Read this manual prior to installation of the product.
3. Read the security information carefully prior to installation of the product.
To Next Page
Loading...