INSTALLATION SHEET
7000 Series Thinline LCD Keypads
Models 7060/7064/7070/7075
Description
The DMP 7000 Series Thinline LCD Keypads offer the same exible features and functionality as current DMP keypads
in a stylish, sleek new design. Each keypad provides four 2-button Panic keys, an AC power LED, an Armed LED,
32-character display, backlit logo and keyboard with easy-to-read lettering and an internal speaker. The 7070 and
7075 keypads provide four fully programmable Class B, Style A protection zones you can program for a variety of
burglary, re, and access control applications. The 7064 and 7075 keypads provide a built-in proximity card reader
specically designed to accept DMP 1400 Series proximity credentials. The Model 7075 also allows connection of any
Weigand output reader.
Installing the Keypad
The keypad housing is designed to easily install on any 4” square box, 3-gang switch box,
695 and 696 backbox, or at surface. Figure 1 shows the keypad housing mounting hole
locations.
Removing the Base
The keypad housing is made up of two parts: the front, which contains the circuit board,
keyboard components, and the base. To mount the keypad, remove the base from the
front by inserting a at screwdriver into one of the openings on the bottom. Twist the
screwdriver while pulling the halves apart. Repeat with the other opening.
Harness Wiring
Figure 1 shows wiring harness assignments. Observe wire colors when connecting the red, yellow, green, and black
wires to the keypad bus. When wiring directly to the panel terminals, connect red to panel terminal 7, yellow to
terminal 8, green to 9, and black to panel terminal 10. Use 1k Ohm EOL resistors, DMP Model 311, on keypad zones
1 through 4.
The 7060 and 7064 keypads are supplied with a 4-wire harness for panel keypad bus connection.
The 7070 and 7075 keypads are supplied with a 12-wire data bus/zone harness. Four wires connect to the keypad
bus, the same way the 7060 and 7064 keypad harness connects. The remaining eight wires are for the four zone
inputs: two wires for each zone.
The 7075 keypad is also supplied with one 5-wire output/reader harness.
Surface and Backbox
Mounting Holes
Combined 4-square
and 3-gang switch box
Mounting Holes
Keypad Back
Surface and Backbox
Mounting Holes
1K EOL
1K EOL
1K EOL
1K EOL
Green/White – Connect Reader Data 0
White – Connect Reader Data 1
Orange – Door Strike Normally Open
Gray – Door Strike Common
Violet
– Door Strike Normally Closed
Yellow/Whit
e
White/Yello
w
Orange White
White/Orange
Red/White
White/Re
d
Brown/White
White/Brow
n
Black – Ground
Green – Receive Data
Yellow – Send Data
Red – Keypad Power
– Zone
4
– Zone
3
– Zone
2
– Zone 1
Output Reader
7075 Keypad
Zones 1 through 4
7070 and 7075
Keypads
All Keypads
Figure 1: Keypad Back Showing Wiring Harness Assignments
To Next Page
Need help?
General