DigitAx User Guide
Issue code: dgxu4
iii
Declaration of Conformity
Control Techniques plc
The Gro
Newtown
Powys
UK
SY16 3BE
DBE140 DBE220 DBE420
DBE600 DBE750 DBE1100S
DBE1500 DBE2200
The DigitAx servo drive products listed above have
been designed and manufactured in accordance
with the following European harmonised, national
and international standards:
EN60249 Base materials for printed circuits
IEC326-1 Printed boards: general information for the
specification writer
IEC326-5 Printed boards: specification for single- and
double-sided printed boards with
plated-through holes
IEC326-6 Printed boards: specification for multilayer
printed boards
IEC664-1 Insulation co-ordination for equipment
within low-voltage systems: principles,
requirements and tests
EN60529 Degrees of protection provided by
enclosures (IP code)
UL94 Flammability rating of plastic materials
UL508C * Standard for industrial control equipment
* Applies to models DBE1500 and DBE2200 only
These products comply with the Low Voltage
Directive 73/23/EEC and the CE Marking Directive
93/68/EEC.
W. Drury
Technical Director
Newtown
Date: 11th November 1998
These electronic Drive products are
intended to be used with an
appropriate motor, controller,
electrical protection components and
other equipment to form a complete
end product or system. The Drive must
be installed only by a professional
assembler who is familiar with the
requirements for safety and
electromagnetic compatibility (EMC).
The assembler is responsible for
ensuring that the end product or
system complies with all the relevant
laws in the country where it is to be
used. This User Guide or the related
EMC Data Sheet should be referred to
for further information on the EMC
standards that the product complies
with, as well as for guidance on
installation.
To Next Page
Loading...
Need help?
General
