Digitax DBE220 User Manual

DigitAx User Guide
Issue code: dgxu4
11-10
b96 At-speed relative/absolute
R–W
0 or 1
Def
.
val.
1 Res.
Defines the type of signal given by the At-speed
status parameter b42.
When b96 is set at 0, absolute is selected.
When b96 is set at 1, relative is selected.
When b96 is set at 1 (relative) the At-speed status
held in b42 is related to the Speed Reference input,
so that b42 = 1 (At speed) when the motor speed is
between the two limits, as follows:
Greater than [Speed reference]
– Pr56
Less than [Speed reference] +
Pr57
When b96 is set at 0 (Absolute) the At-speed
status held in b42 responds to the absolute values
set in Pr56 and Pr57, so that b42 = 1 (At speed)
when the motor speed speed is between the two
limits, as follows:
Greater than Pr56
Less than Pr57
Refer also to Pr56, Pr57 and b42.
b99 Save RAM to EEPROM
R–W
0 or 1
Def
.
val.
0 Res.
Saves new parameter values in the EEPROM. The
display shows SAVE while parameters are being
saved. b99 is related to b1 and b5.
When b99 is set at 0, no saving occurs.
When b99 is set at 1, parameters are saved.

Digitax DBE220 Specifications

General

Brand	Digitax
Model	DBE220
Category	Controller
Language	English