DigiTech GE4107 User Manual

3
34) TARGET LIGHT
35) HEADSHELL
36) EJECT
37) POSITION FOR PREPARING CARTRIDGE
38) COUNTERWEIGHT
39) ANTI-SKATE KNOB
40) LIFT LEVER
41) TONE ARM REST PART
42) PITCH CONTROL SLIDER (+/- 10%)
43) TURNTABLE FOOT
44) FM WIRE ANTENNA
45) SPEAKER SOCKET
46) LINE-OUT SOCKET
47) GROUND TERMINAL
48) AC POWER CORD
CAUTION:
USAGE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULTE IN HAZARDOUS RADIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE
PERSONNEL.
WARNING:
- THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING AND THAT NO
OBJECTS FILLED WITH LIQUIDS, SUCH AS VASES, SHALL BE PLACED ON THE APPARATUS.
- BATTERIES (BATTERY PACK OR BATTERIES INSTALLED) SHALL NOT BE EXPOSED TO
EXCESSIVE HEAT SUCH AS SUNSHINE, FIRE OR THE LIKE.
- THE MAINS PLUGS OR AN APPLIANCE COUPLER IS USED AS THE DISCONNECT DEVICE, AND
THE DISCONNECT DEVISE SHALL REMAIN READILY OPERABLE.
PRECAUTIONS FOR USE
INSTALLATION
1* UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
2* DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS VOLTAGE AND BEFORE ALL
OTHER CONNECTIONS HAVE BEEN MADE.
3* DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF SEVERAL CENTIMETERS
AROUND THE UNIT FOR VENTILATION.
CONNECTION
1. PLUG THE UNIT INTO A SUITABLE MAINS SOCKET
2. CONNECT EXTERNAL SPEAKERS (NOT INCLUDED) TO THE SPEAKER SOCKETS
3. TURN THE POWER SWTICH CLOCKWISE TO ENTER TO STANDBY MODE, STANDBY INDICATOR WILL BE
ON. THE STROBE ILLUMINATOR WHICH IS LOCATED BENEATH THE SWTICH WILL LIGHT UP.
4. PUSH THE STANDBY BUTTON, STANDBY INDICATOR WILL BE OFF, UNIT IS READY FOR OPERATION.
BLUETOOTOOTH CONNECTION
- PRESS FUNCTION BUTTON REPEATEDLY TO SELECT BT MODE (BLUETOOTH), THEN THE UNIT IS
READY FOR CONNECTION WITH YOUR BLUETOOH DEVICE (SUCH AS MOBILE PHONE).
- SWITCH ON THE BLUETOOTH FUNCTION OF YOUR BLUETOOH DEVICE, AND SELECT “GE4107” BLUE-
TOOTH EQUIPMENT FOR CONNECTION.
- AFTER YOUR BLUETOOH DEVICE IS CONNECTED WITH THE UNIT VIA BLUETOOTH, START TO PLAY-
BACK YOUR DEVICE.
SETTING THE CLOCK
1 WHEN THE STANDBY INDICATOR LIGHTS UP, THE UNIT IS IN THE STANDBY MODE.
2 DURING STANDBY MODE, SELECT BETWEEN 12H OR 24H CLOCK OPTIONS:
3 PRESS AND HOLD MODE BUTTON FOR 3-5 SECONDS; 12H / 24H WILL BE FLASHING. PRESS SKIP DOWN
BUTTON OR SKIP UP BUTTON TO SELECT 12H / 24H MODE. PRESS MODE BUTTON AGAIN TO
CONFIRM.
4 SETTING HOUR: PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE CORRECT
HOUR. PRESS MODE BUTTON AGAIN TO CONFIRM.
5 SETTING MINUTE: AFTER STEPS 2 & 3 ARE COMPLETED, PRESS SKIP DOWN BUTTON OR CD 1 -
SKIP UP BUTTON TO SELECT CORRECT MINUTE. PRESS MODE BUTTON AGAIN TO CONFIRM.

DigiTech GE4107 Specifications

General

Brand	DigiTech
Model	GE4107
Category	Turntable
Language	English