4
SETTING ALARM
1. DURING STANDBY MODE, HOLD TIMER BUTTON FOR 3-5 SECONDS. SETTING THE ALARM SEQUENCE
IS “ALARM ON TIME > ALARM OFF TIME > ALARM MODE > ALARM VOLUME”.
2. SETTING ALARM ON TIME: “ON” IS ILLUMINATED ON THE DISPLAY
2.甲.i. SETTING HOUR: PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE
CORRECT HOUR, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
2.甲.ii. SETTING MINUTE: PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE
CORRECT MINUTE, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM
3. SETTING ALARM OFF TIME: “OFF” IS ILLUMINATED ON THE DISPLAY:
3.甲.i. SETTING HOUR: PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE
CORRECT HOUR, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
3.甲.ii. SETTING MINUTE: PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE
CORRECT MINUTE, THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
4. SETTING ALARM MODE: “TUNE”, “CD”, “USB” OR “CARD” IS ILLUMINATED ON THE DISPLAY:
4.甲.i. PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE ALARM MODE,
THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
4.甲.ii. “TUNE”, “CD-1”, “USB” OR “CARD” (=SD CARD) ARE AVAILABLE FOR ALARM MODE
SELECTION.
5. SETTING ALARM VOLUME: “V - ” IS ILLUMINATED ON THE DISPLAY:
5.甲.i. PRESS SKIP DOWN BUTTON OR SKIP UP BUTTON TO SELECT THE ALARM VOLUME,
THEN PRESS TIMER BUTTON AGAIN TO CONFIRM.
6. WHEN SETTING THE ALARM IS COMPLETE, THE DISPLAY WILL SHOW THE SETTING AGAIN FOR
CLARIFICATION.
7. “CLOCK” ICON WILL BE FLASHING WHEN ALARM IS IN ACTIVE. “CLOCK” ICON LIGHTS UP WHEN ALARM
SETTING IS STORED BUT NOT IN ACTIVE YET.
8. CANCEL ALARM: DURING STANDBY MODE, WHEN “CLOCK” ICON IS ON, PRESS TIMER BUTTON, “CLOCK”
ICON WILL TURN OFF.
SNOOZE FUNCTION
PRESS SNOOZE BUTTON WHEN ALARM IN ACTIVE, ALARM WILL BE SLIENT FOR 10 MINUTES. AFTER 10-
MINUTUE SNOOZE INTERVAL, ALARM WILL BE ACTIVE AGAIN. SNOOZE CAN BE USED FOR REPEATEDLY
WITHIN THE 1-HOUR ALARM ACTIVE INTERVAL.
TIMER FUNCTION
1. WHEN THE UNIT IS TURNED ON (STANDBY INDICATOR LIGHT IS OFF), PRESS SLEEP BUTTON
REPEATEDLY TO CHOOSE THE DESIRED SLEEP TIME MINUTES FROM 90>80>70…..>10 OFF.
2. SLEEP TIME SETTING IS STORED WHEN THE “SLEEP” ICON LIGHTS UP ON THE DISPLAY.
LISTENING TO RADIO & RECORDING TO USB/SD
NOTE: IT IS RECOMMENDED THAT A 4GB MEMORY STICK IS USED WHEN RECORDING TO USB
RADIO TUNING
1. PRESS FUNCTION BUTTON TO SELECT “TUNE” MODE.
2. SELECT THE DESIRED BAND BY RADIO BAND BUTTON.
3. TUNE TO THE REQUIRED STATION BY PRESSING SKIP UP OR SKIP DOWN BUTTON FOR 1-2 SECONDS,
AND THEN RELEASE.
4. RADIO FREQUENCY CAN ALSO BE ADJUSTED MANUALLY BY PRESSING AND RELEASING SKIP UP OR
SKIP DOWN BUTTON IMMEDIATELY.
5. THE UNIT WILL START SEEKING AUTOMATICALLY AND STOP WHEN A RADIO STATION IS FOUND.
To Next Page
Loading...
Need help?
General
