5
MANUAL PRESET RADIO STATIONS
1. WHEN THE DESIRED RADIO STATION IS FOUND, PRESS MODE BUTTON, PROGRAM NUMBER WILL BE
FLASHING.
2. PRESS PRESET UP OR PRESET DOWN TO CHOOSE THE PROGRAM NUMBER FOR STORING THE
DESIRED RADIO STATION.
3. PRESS MODE BUTTON AGAIN TO CONFIRM, PROGRAM NUMBER WILL STOP TO FLASH.
4. REPEAT STEP 2 & 3 UNTIL ALL DESIRED RADIO STATIONS IS BEING FOUND AND STORED
5. PRESS PRESET UP OR PRESET DOWN TO CHOOSE THE PRESE RADIO STATIONS.
6. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
ATUO PRESET RADIO STATIONS
1. DURING RADIO MODE, PRESS THE PLAY/PAUSE BUTTON, THE UNIT WILL AUTOMATICLLY SCAN THE
RADIO FREQUENCY. WHEN THE CLEAR SIGNAL IS FOUND, IT WILL AUTOMATICALLY STORE THE RADIO
STATION, STARTING FROM PROGRAM NUMBER 1.
2. THE NUMBER OF STATIONS CAN BE FOUND AND STORED IS DEPENDED ON THE RECEPTION OF
DIFFERENT AREA AND COUNTRIES.
FM & FM-STEREO RADIO RECORDING TO USB/SD
3. PRESS FUNCTION BUTTON TO SELECT “TUNE” MODE AND SELECT THE DESIRED BAND BY BAND
BUTTON.
4. INSERT MEMORY DEVICE (USB DRIVE, SD OR MMC CARD)
5. PRESS THE REC BUTTON; IT WILL TAKE 3-5 SECONDS TO READ MEMORY DEVICE. THEN USB OR SD
ICON WILL BE FLASHING.
6. PRESS SKIP UP OR SKIP DOWN BUTTON TO SELECT DESIRED MODE (USB OR SD) FOR
ENCODING. THEN PRESS REC BUTTON AGAIN TO CONFIRM. AND THE SYSTEM IS STARTING THE
ENCODING MODE AFTER FEW SECONDS.
7. IF ONLY USB DRIVE, SD OR MMC CARD IS INSERTED, STEP 4 CAN BE SKIPPED.
8. THE USB OR SD ICON WILL BE FLASHING ON THE DISPLAY DURING ENCODING.
9. TO FINISH RECORDING, PRESS REC BUTTON AGAIN AND DISPLAY WILL SHOW “END” AND RETURN TO
TUNER MODE.
PHONO & ENCODING
NOTED:
- INSTALL THE DUST COVER INTO HINGE ON THE UPPER CABINET.
- SET THE TURNTABLE PLATTER ONTO THE CENTER SPINDLE.
To Next Page
Loading...