6
- ATTACH THE DRI VE BELT: POSITION THE BELT ON THE MOTOR PULLY, THE DRIVE BELT IS TIG HTENED
UNDER THE TURNTABLE PLATTER.
- PLACE THE SLIP MAT ON THE TURNTABLE PLATTER.
- INSERT THE HEADSHLL INTO THE FRONT END OF THE TONEARM, THEN SCREW THE LOCK NUT WITH
THE HEADSHELL FIRMLY HELD HORIZONTALLY.
-
- SLIDE COUNTERWEIGHT ONTO THE TONEARM. TWIST IT LIGHTLY AND IT WILL SCREW INWARDS ONTO
THE REAR END OF THE TONEARM.
- FOR THE DEFAULT AUDIO-TECHNICA AT-3600L CARTRIDGE, TURN THE CUONTERWEIGHT INWARD TILL
IT REACH THE HORIZONTAL LINE AS BELOW:
To Next Page
Loading...