Amp Input/Preamp Loop – Integrates the GSP1101 into a guitar amplifier system
that has an effects loop. Use this setup when you want to use the tone of your
amplifier (rather than the GSP amp modeling) or switch between internal amp models
and your amp’s preamp with the pre-amplifier stompbox and post-amplifier effects the
GSP1101 offers.
Connect your guitar
to the Input on the
GSP1101 front panel.
Connect the GSP1101
Loop Send to the
amp’s Input.
Connect the
amp’s Loop
Send to the
GSP1101
Loop Return.
Connect the
GSP1101 Line
Out to the
amp’s Loop
Return.
To use the Setup Wizard
Press and hold the Tuner button until the Setup Wizard screen appears in the display
The first screen prompts you to select from the seven most common setups we have
just reviewed. Use the Edit/Select knob to navigate through these setups and select
the one which matches how you’ll connect the GSP1101.
The next series of screens guide you through the different options available for your
selected type of setup. Respond to each question and make your selections using the
Edit/Select knob.
Once all options have been configured, the message Review Your Selections appears.
Scroll through these options to ensure they have been answered correctly. Once
confirmed, press the Edit/Select knob to complete the configuration process. You’ll
exit the Wizard and return to the Preset screen.
The GSP1101 is now optimized for use with your setup.
7.
1.
2.
3.
4.
GSP0 Owner’s Manual
Using the GSP0
To Next Page
Loading...
Need help?
General
