DigiTech HardWire series User Manual

13
Hook-and-loop Pedalboard Pad
To attach the Pedalboard Pad, do the following:
1. Peel off the existing rubber skid pad from the bottom of the pedal.
2. Peel the adhesive protector from the back of the Pedalboard Pad.
3. Apply the Pedalboard Pad to the bottom of the pedal.

DigiTech HardWire series Specifications

General

Construction	Metal Chassis
Power Supply	9V DC
Series	HardWire series
Power Requirements	9V DC (center negative)
Input Impedance	1M ohm
Output Impedance	1k ohm
Bypass	True Bypass