6 Compressor
7 Distortion
8 Delay
9 Patch Bank Up
10 Patch Bank Down
11 Noise Gate
10 Patch bank names
10 X 16 array that contains the name of each of the 10 patch banks.
10 Patch bank program numbers
10 x 6 array that contains the program to be switch to if the corresponding
byte in the patch byte definition array is set to Program Select. A byte of
0 corresponds to program 1
Global Amp Voicing value
The value of Amp Voicing if the Amp voicing parameter is set to Global Voice
0 Flat
1 High Boost
2 High&Low Boost
3 Low Boost
GSP7 Parameters
The GSP7 parameters are listed in alphabetical order. The display value of
the parameter is given if the display value is different then the parameter
value.
To Next Page
Loading...
