SAFETY
This symbol indicates that the operator must refer to an explanation
in the Operating Instructions to avoid personal injury or damage to the
meter.
CAUTIONS
• Improper use of this meter can cause damage, shock, injury or death.
Read and understand this user manual before operating the meter.
• Always remove the test leads before replacing the battery o fuses.
• Inspect the condition of the test leads and the meter itself for any
damage before operating the meter.
• Do not measure voltage if the voltage on the terminals exceeds 1000V
above earth ground.
• Use great care when making measurements if the voltages are greater
30VAC RMS or 60VDC, these voltages are considered a shock hazard.
• Always discharge capacitors and remove power from the device to be
tested before performing Diode, Resistance or Continuity tests.
• To avoid damages to the meter, do not exceed the maximum limits of
the input values shown in the specications.
• If the multimeter is going to be unused for an extended period of time,
remove the batteries to prevent them from draining.
To Next Page
Loading...