FUNCTIONS
LCD Screen Readings and measurements taken by the multimeter
will display in this area.
Function
Buttons
HOLD: Press this button to lock the readings in the LCD,
press again to exit the hold mode.
Press “ ” to switch the back light mode, around 15
second exit from back light mode.
Rotary Switch Moving the rotary switch to each individual range of
measurement or to the range needing to be measured
will also power on the unit.
Input Jacks V/Ω: The positive input terminal for voltage, resistance,
diode, temperature, frequency, capacitance, etc.
COM: the negative input terminal for voltage, diode,
temperature, etc.
mA: the input terminal for lower 200mA current
A: 10A input terminal.
Functions FUNC: Activates secondary functions where available -
primarily for use with diode or continuity testing
REL: Stores reading and resets display to zero. Sets a
relative reference point to measure against the next
reading.
MIN/MAX: Stores input values; beeps when a value is
breached and a new value is set.
To Next Page
Loading...