WIRING DIAGRAM:
QC3530 or QC3532 cameras are recommended.
The camera is powered by taking 12vdc from the wiring to a Reverse Light. An extension
cable with Yellow plugs on each end sends the video from the camera to the head unit.
An additional Reverse Switch red wire in the extension cable is used to send a +12vdc
signal to the head unit to switch -on the reverse camera video when you select reverse.
Connecting a second camera :
Connect Yellow plug to
R-Cam socket
Reverse switch wire –
camera end: Connect the
Red wire in extension cable
to +12vdc at the camera
power connection
Use the same connection
as the Camera Power
+12vdc Red wire so it only
sends +12vdc when the
camera is on.
Camera power cable:
Connect Red wire to Reverse
Light +12vdc.
Connect Black wire to
ground or Reverse Light -
12vdc.
Reverse switch wire – head unit end: Connect Red
wire in video extension cable to U14 cable
Back of
the
head
unit
Extension cable with
Video signal and
Reverse Switch wires
Camera Power cable
Connect the U13 wire
to ground via your
handbrake to enable
video playback from
USB sticks.
Connecting an optional reversing camera so your head unit displays video
automatically when you select reverse gear.
Connect a camera to the F-Cam socket and you can manually display the camera
video by pressing the F-Cam icon on the head unit screen. You will not need to
connect the Reversing Switch red wires in this case – just connect the Camera power
Red wire to +12vdc, black power wire to - 12vdc, and connect the video cable
yellow plug to the F-CAM socket.
To Next Page
Loading...
Need help?
General
