2. Press the silver button in the lower stem, and slide the stem into the middle
stem.
3. Press the silver button in the middle stem, and slide the stem into the S stem.
Tighten the lock nut on the S stem.
4. Press the silver button in the top stem, and slide the top stem into the S stem.
5. Adjust the stem to a length that you feel comfortable when you stand upright with
the detector in your hand, and the search coil is level with the ground with your
arm relaxed at your side. Then counter-clockwise rotate to tighten the lock nut on
the middle stem.
6. Fix the control box on the S stem and tighten the fixing screw properly.
Wind the search coil cable around the stem. Insert the search coil’s cable plug into
the five-pin jack at the back of the control box.
Caution:
l Do not over-tighten the search coil or use tools such as pliers to tighten it.
l The search coil’s plug fits into the connector only in one way. Do not force the plug
and do not pull on the cable or you could damage it.
7. Stand and stretch your arm, holding the metal detector to make the search coil
above the ground for about 1 to 5 cm. Rotate the stem’s lock nut counterclockwise
to tighten it.
To Next Page
Loading...