Function：
：：
：
* Complies with Serial ATA International Organization:
Serial ATA Revision 2.6
* Supports SATA 1.5G/3.0G Speed
* Supports SATA Hot swap
* Supports SATA Host/Device controller configuration
* Complies with USB 2.0 electrical specification
* Supports USB 2.0 High-Speed and Full-Speed
* Complies with USB Mass Storage Class, Bulk-Only Transport
Specification
* Supports clone function
*Supports
Win 98/ME/2000/XP/VISTA /WIN7 MAC OS 9.X/10.X /Linux
CLONE:
Please note the below conditions before clone:
- Bay ‘A’ = SOURCE HDD,
- Bay ’B’ = TARGET HDD
- TARGET HDD ‘s capacity MUST be larger than SOURCE
HDD, otherwise the CLONE cannot be completed. (Same
capacity is also not acceptable)
- Before CLONE function starts, make sure the information
in TARGET HDD is not important; once CLONE started, all
information from the SOURCE HDD will be covered into
TARGET HDD..
- Once the docking is connected to USB interface, the offline
Clone will be invalid. Clone can only process by using USB
Clone Function.
To Next Page
Loading...