(3) Power on the handhold microphone In case of any frequency interference,press
the set button on the microphone and the microphone will be tuned to a different
frequency. There are up to eight frequencies to choose from.
(4) Please note that it will take a few seconds for the receiver to automatically
syndicate the frequency with the microphone each time the set button is
pressed.
(5) To connect the receiver to a device such as a computer, TV, and speaker, etc.,
please refer t
o the connection diagram shown below.
How to match the receiver
1. In the power-on state, the frequency and channel will be displayed alternately.
2. After 90 seconds of use in the power-on state, only the battery status and launch
status will be displayed. While the frequency is not displayed, Touch the
SET\POWER button to activate the display frequency and channel.
3. In the power-on state, the microphone does not detect the sound within 5
minutes, it will enter the lower po
wer consumption, only the battery status is
displayed. (The receiver light does not display blue.) Tap the SET\POWER
button to activate the display frequency and channel. Or speaking to the
microphone activates the launch.
4. In the play state. If there is no button action and no sound for more than 15
minutes, the microphone will automatically off. To press the POWER button to
turn it on.
3 - EN
To Next Page
Loading...