Need help?Do you have a question about the Digitus DA-70157 and is the answer not in the manual?
General| Category | Media Converter |
|---|---|
| Model | DA-70157 |
| Ports | 1 x RJ45, 1 x SC |
| Fiber Optic Connector | SC |
| Maximum Transfer Distance | Up to 20 km |
| Transmission Distance | Up to 20 km |
| Data transfer rate (Ethernet) | 10/100/1000 Mbps |
| Fiber Mode | Single-Mode |
| Fiber Mode Type | Single-Mode |
| Wavelength | 1310 nm |
| Transfer Distance | Up to 20 km |
| Power Supply | 5V DC |
| Operating Temperature | 0°C to 50°C |
| Weight | 0.2 kg |
Connects the converter to USB and starts the Found New Hardware Wizard for driver installation.
Selects manual driver installation and specifies search locations, including CD-ROM.
Chooses the appropriate driver from the list and proceeds with the software installation.
Identifies the newly assigned COM port for the installed USB serial converter.
Opens system properties to access the Device Manager for installed hardware.
Details how to find the installed 'USB Serial Converter' and 'USB Serial Port' entries.
Examines the device properties and configures advanced settings like 'Load VCP'.
Reconnecting the device to confirm successful installation and configuration.
Opens the dedicated utility to uninstall FTDI drivers from the system.
Starts the process to remove all associated FTDI drivers and related files.
Confirms uninstallation prompts and exits the utility after successful removal.
To Next Page
