4
Hardware Installation
1. Turn on your PC and boot fully.
2. Plug the Mini-type connector into the upstream port
3. Plug the A-type connector into a computer or USB hub
downstream port
4. Your OS will install the Hub automatically or follow the
instructions of your OS.
5. After fully installation you can connect USB devices or
hubs to the hub’s downstream ports.
Important Note:
The Hub must be connected to a USB 2.0-compliant host in
order to function in high-speed mode (480Mbps data rate).
If the Hub is connected to a USB 1.1-compliant host, it will
operate only in low-speed or full-speed mode
(1.5Mbps/12Mbps).
To Next Page
Loading...
