Device Mode (USB3.0 to SATA External Dual Hard Drive)
• Install your SATA hard drive properly to the port
connector on the docking station
• Connect the docking station to your computer
by USB cable
• Connect the power adapter to the enclosure and
power up the docking station
• The computer should now detect the new hardware.
For Windows2000/XP/VISTA/7/8/10, no driver setup is
necessary.
• Please Proceed to step 6.0 to format your drive.
Duplication Mode
• Install 2 hard drives into the dock. Make sure to place the
drive with the data you want copied (Source) into the
“Source” bay. The target disk (Target) should be equal or
larger in capacity than the source disk.
• Connect the power adapter to the enclosure and press
the POWER button to power up the docking station.
• After about 10 seconds, keep pushing the CLONE button
for 3 seconds to begin duplication.
Clone Progress indicator (25%, 50%, 75% and 100%, 4
status) would be acted.
To Next Page
Loading...
